Codes for changing settings or diagnosing issues with the Stromer ST1.
Step-by-step guide
Entering the Programming Menu
- Hold down the power button and the plus
button on your console for three seconds.
- The screen will change to show four "0" with the far right "0" blinking.
- Use the
and
buttons on the console to select the desired code from 0 to 9. Press the power button on the far left to advance to the next place.
- Once you have selected your desired code, hold down the power button to enter your code choice.
- You should now be in the selection screen where you can select your desired value with the
and
buttons.
- Save your selection by holding down the power button for three seconds.
- Hold down the power button and the plus
- Enter the appropriate code from the list.
Code | Description | Value |
---|---|---|
9999 | Full Reset | 0=No 1=Yes |
0001 | Set Day/Time | |
0003 | Select unit of measure either KM or MI | 0=km 1=mi |
0004 | Set Lock PIN (Manually selecting a lock pin must be enabled with code 1008)(Default code is 1234) | 0000-9999 |
0005 | Set Backlight Contrast | 0-5 |
1004 | Set Sensor Sensitivity | 10 (Low) - 90 (High) |
1005 | Boost Mode Enable | 0=off 1=on |
1006 | Move Mode Enable | 0=off 1=on |
1008 | Lock PIN Enable | 0=off 1=on |
1009 | Recuperation Mode Enable | 0=off 1=on |
2000 | Show Display FW Version | |
2001 | Show Motor FW Version | |
3771 | Set Total Distance | 0000-9999 |
3777 | Set Move Mode Speed | 1 (Slow) - 3 (Fast) |
Give our service department a call at 415-524-7362 or email us. Still Having Issues?
Related articles